Recording from a compact disc, 1 insert a cassette, 2 set the function switch to cd – Aiwa CSD-ES370 User Manual
Page 22: 3 place a disc with the iabel facing up, 4 press the # rec button to start recording, 5 press the ►!! play/pause button to start cd piay, Basic operation, After recording, Recording programmed tracks, Information on recording in general
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FUNCTION
CSD-ES770
OPE/BATT/DIR
CSD-ES770
PLAY REC
CSD-ES570/ES370
PLAY REC
PLAY/PAUSE
RECORDING FROM A COMPACT
DISC
Recording is done on the side facing the cassette hoider.
Use type I (normai) tapes.
1 Insert a cassette.
(D
The side to be recorded on
2 Set the FUNCTION switch to CD.
For CSD-ES770, make sure that the <l light of the OPE/BATT/DIR
indicator is on. If it is not on, press the DIR button to turn it on.
3 Place a disc with the iabel facing up.
4 Press the # REC button to start recording.
The PLAY button is depressed automaticaliy.
The REVERSE MODE button is also depressed (CSD-ES770
only).
5 Press the ►!! PLAY/PAUSE button to start CD piay.
Basic operation
Press the following buttons.
To stop M/^ STOP/EJECT button of the deck
■ STOP/MEMORY button of the CD player
To pause
II
PAUSE button
_____________Press again to resume recording.____________
After recording
Set the FUNCTION switch to POWER 6 STANDBY/TAPE.
Recording programmed tracks
1 Follow steps 1 to 6 on page 14.
2 Insert a cassette.
3 Press the # REC button.
4 Press the ►!! PLAY/PAUSE button on the CD player.
Information on recording in general____________________
When the end of the tape is reached
CSD-ES770
The 9 REC button is released and recording stops. But the
PLAY button is not released and the tape reverses. Press the 9/^
STOP/EJECT button to stop the tape.
To record on the other side, turn the cassette over.
CSD-ES570/ES370
Recording stops and the buttons are released.
To record on the other side, turn the cassette over.
Usable tapes
Use type I (normal) tapes. If you use type IV (metal) or type II (high/
Cr
02) tapes, sound that has been already recorded may not be erased
completely.
NOTE
■ You cannot change the setting of the FUNCTION switch during
recording.
' If the erasure prevention tab on a cassette is broken off, the
9
REC
button cannot be depressed.
Adjusting the output volume and sound does not affect the recorded
sound.
When recording near a television, noise may be recorded. Move the
unit further away from the television.
22