A&D GR Series GR-300 - Manual (Page 48)

Caution
□ When weighing data is being placed in memory, the data can be not
output to the RS-232C interface.
□ The " h i l L " means full memory. More data can be not stored until
deletion of the stored data.
□ Automatic self calibration can not be used while the interval memory
mode is working.
□ The following commands can not be used during data storage.
Q Query command for weighing data.
S Request command for stable weighing data.
SI Query command for weighing data.
SIR Request command for continuous weighing data.
Preparation of the Function Tabie
Item
Mode ^
Data output
mode
Auto-print
polarity
Data memory
function
Interval time
Key mode
n /
n
1 1 L U
J
n L n 1
LI 1 1 L 1 1 1
Auto-Print Mode A n _ /
‘
•
L 1
n n
n n -f
III 1
u /
n
n 1 ri ~l
III II II
1 ri 1 n 1
LI 1 1 L 1 1 1
Auto-Print Mode B 0 . L D
1 1 L L
1 n L
n
1
LI 1 1 L 1 1 1
Interval Memory Mode O _ L
r/
II L J
1 n L n 1
LI I 1 L 1 1 1
1 ri n
11 1 L U U
Not used data number 1 n
LI 1 1 O LI
Use data number 1
!
LI 1 1 O I
Note
The data memory function does not
work with o',9 1 /i' i j .
Output of Data from Memory
Displaying and Transmitting the Data
Step 1 Press and hold the PRINT key until displaying
the key.
r r O ' '
r r I I l f I
and release
Step 2 Press the [PRINT key to enter the mode. Use the following keys.
The key to proceed to the next data.
The key to go back to the previous data.
RE-ZERO key
MODE I key
PRINT key The key to transmit the current data to the
RS-232C interface.
RANGE key is pressed and The keys to delete the current data
held then press the [CAl] key
CAL j key The key to exit this mode.
Step 3 Press the ¡CALj key. The balance returns to weighing mode.
Functions page 47 11, Data Memory Function