Akai Multi Video Processor RMD-V3104U - Manual (Page 12)

TROUBLESHOOTING
What seems to be a malfunction is not always so. In case of trouble, first check the list of common problems in the
following table. Equipmentconnected to the unit can also cause problems, therefore it is necessary to check all this
equipment as well. If the problem is not resolved after performing the recommended steps above, please contact
your dealer.
^ Problem Cause Remedy Ref. Page^
Power cannot be
turned ON.
The power cord is unplugged from the
power outlet.
Insert the power cord into the power
outlet.
6
Images are not
displayed.
The unit is not correctly connected to
other equipment.
Connect it correctly with other
equipment.
6, 8
An incompatible signal is being sent
to the unit.
Apply a compatible signal to the
unit.
12
The INPUT switch is not properly set. Properly set the INPUT switch and
press the reset button.
8
V_________________
The MODE switch is not properly set. Properly set the MODE switch and
press the reset button.
9
J
Note on the input signal
The image may not properly display if any of the following types of signals are input.
• VCR signal obtained after repeated dubbing (copies).
• VCR or DVD signal containing copy guard signals.
• Signals other than the V IN standard signal.
Notes on the input image
1. Colored letters (characters) or letters with a colored
background may become hard to read due to the
blurring of colors. (Therefore it is recommended
that these letters (characters)and backgrounds not
be used.
2. Horizontal linesconsistingoffiner lines may become
hard to view due to flickering.
Note on genlockinq
This unit does not incorporatethe genlocking function.
This means that the output signals from this unit are
not synchronized with the signals input to this unit.
12
<ARE1336>
En