Installing and removing boards, Instamation procedure, Removal procedure – Akai Multi Video Processor RMD-V3104U User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MVP MANUAL
9. INSTALLING AND REMOVING BOARDS
• Be sure to turn the power off before installing
and removing boards.
<InstaMation procedure>
© Remove the screws from the front panel, then
open the front panel. (Fig. A)
2 Insert the board gently along the rails.
Refer to the board layout for the positions for in
serting the boards.
©
Press
the
part
of
the
white
plastic
part
strongly with a finger and insert the board fully
to the back. (Fig. C)
* The board may not go fully to the back if pressed
on the metal part.
4 Fasten with the flanged screws (3x6). (Fig. C)
® Set the front panel back in place.
<Removal procedure>
© Remove the front panel.
2 Remove the screws fastening the board to the
removed. (Fig. C)
© Lift the ejectors indicated with white arrows. (Fig.
B)
® Gently draw out the board along the rails.
2 Set the front panel back in place.
(Fig. B)
(Fig. C)
158
For your safety