Connection with mvp external computer – Akai Multi Video Processor RMD-V3104U User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MVP MANUAL
2. CONNECTION WITH MVP EXTERNAL COMPUTER
• Refer to Chapter 4.(P.105) "External Control by MPJ RS-232C” for how to adjust the MPJ.
• Use a RS-232C straight cable.
• Refer to the following diagram for connections.
• MVP RS-232C Settings
Baud rate
Bit number
Parity
Stop bit
2400, I 4800 I , 9600, 19200
7, [8
INON I , ODD, EVEN
[1,2
Setting at shipment
This setting can be changed using the DIP switches on the panel.
Refer to "Chapter 2.(P.19) MVP panel 7 Baud rate switch”.
<MVP RS-232C Pin Layout>
Signal name
13
u
14
FG
Frame Ground
Tx
Trandmitted Data
Rx
Received Data
RTS
Requenst to Send
CTS
Clear to Send
DSR
Data Set Ready
SG
Signal Ground
25
Connection with External Computer
<External Computer Side>
Straight
<Video Processor Side>
RS-232C IN
FG
1
1
FG
TxD
2
2
RxD
RxD
3 ^- - - - - - - - -
3
TxD
RTS
4
—>
4
CTSl
CTS
5 <
-------------
5
RTSl
*
DSR
6 <
-------------
6
DSRl
SG
7
7
SG
Pins 4, 5 and 6 are short-circuited inside.
Pins not shown in the diagram are NC.
141
1