3) to store the picture frame data [&w command, 4) to load the picture frame data [&l command – Akai Multi Video Processor RMD-V3104U User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MVP MANUAL
(3) To store the picture frame data [&W command]
Input :
&W0, &W1
Explanation : &W0 : Sets the saved values to the settings at shipment.
(Load data using the &L command.)
&W1 : Saves the value adjusted.
• The parameters saved by the &W command are as follows.
• Picture frame data (Data changed by the &G command.)
• Screen start position data (Data changed by the &P2 command and &Q2 command.]
•
Note: When this command is executed, the setting will be saved even if the power is turned off.
Therefore, aii precious settings wiii be erased.
(4) To load the picture frame data [&L command]
Input :
&L0, &L1
Explanation : &L0 : Loads the picture frame data set at shipment on the RAM.
&L1 : Loads the picture frame data saved at the end on the RAM. (Data when power is turned on)
• The parameters loaded by the &L command are as follows.
• Picture frame data (Data changed by the &G command.)
• Screen start position data (Data changed by the &P2 command and &Q2 command.)
• Use this command to reference the adjustment data temporarily.
150