Installation – Desa VGL18NRA User Manual

Page 17

Advertising
background image

www.desatech.com

112882-01D

17

INSTALLATION

Continued

Figure 21 - Connecting Wires

Control
Valve

White Wire
From Receiver

Red Wire From
Receiver

8. Install remote receiver into receiver bracket

using pads and push button clips provided

with receiver (see Figure 20).

9. Connect wires to control valve at the TPTH and

TH locations as shown in Figure 21. Note: Make

sure excess wire does not interfere with burner

or pilot.

10. If heater was removed from fireplace before

installation of remote accessory, see Installing

Heater Base Assembly on page 13 to reinstall

heater into fireplace. Test gas connection for

leaks (see Checking Gas Connections, pages

15 and 16).

11. If logs were removed from heater for install

remote accessory, replace logs (see Installing

Logs, pages 18 and 19).

Figure 20 - Installing Remote Receiver

Push Button
Clips

Bracket

Battery
Clip

9-Volt
Battery

Terminal
Wires

Pad

Installing Batteries for Remote Receiver
and Hand Held Remote Control
Two 9-volt alkaline batteries (not included) are

required to operate this heater with the wireless

hand-held remote control set. One battery must

be installed in the receiver and one in the hand-

held remote control unit. Note: Only use alkaline

batteries.

Installing 9-Volt Battery in Receiver

1. Locate back of receiver behind receiver

bracket mounted on base assembly.

2. Locate the battery clip mounted on the back

of the receiver (see Figure 20).

3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.

Installing 9-Volt Battery (Not Included) in Hand-
Held Remote Control Unit

1. Remove battery cover on back of remote

control unit.

2. Attach terminal wires to the battery. Place

battery into the battery housing.

Battery Cover

9-Volt
Battery

Terminal
Wires

Battery
Housing

Remote
Control
Unit

Figure 22 - Installing Battery in Hand-

Held Remote Control Unit (CGHRCB

Series)

Figure 23 - Installing Battery in Hand-

Held Remote Control Unit (CGHRCTB

Series)

Battery
Housing

9-Volt
Battery

Terminal
Wires

Battery
Cover

Remote
Control Unit

Advertising
This manual is related to the following products: