Connecting the monitor – 3DLABS Wildcat III 6110 User Manual

Page 14

Advertising
background image

Software Configuration

3Dlabs Graphics Accelerator Card User's Guide

If you are upgrading the graphics card in your system

NOTE:

These instructions may be different than how you normally upgrade your graphics
card or other devices, but have been found to be the best method of insuring a
successful installation of your new hardware and software.

1.

Uninstall the drivers for your old graphics card. Refer to your old graphics card’s documentation
or Help files for instructions on removing or uninstalling the old graphics card’s driver software.

2.

Remove the existing graphics card from your system. To install your Wildcat III 6210 or Wildcat
III 6110 Graphics Accelerator Card, see the hardware installation instructions.

3.

Install the Wildcat III 6210 or Wildcat III 6110 Graphics Accelerator Card driver software; see
“Installing the Driver Software” later in this chapter.

Connecting the Monitor

The Wildcat III 6210 supports six standard external connectors:

1. Primary and Secondary DVI-I output ports (also support analog monitors with

additional adapter)

2. One Genlock In connector
3. One 3-Pin, MiniDIN Stereo Sync Output connector
4. Multiview In and Multiview Out ports


The Wildcat III 6110 supports connections for three standard external connectors:

1. Primary and Secondary DVI-I output ports (also supports analog monitors with

additional adapters)

2. One 3-Pin, MiniDIN Stereo Sync Output connector

Wildcat III 6210 Input/Output panel

Wildcat III 6110 Input/Output panel

NOTE:

Dual-monitor support is not available under Windows NT.

Advertising
This manual is related to the following products: