3DLABS Wildcat III 6110 - Manual (Page 2)

3Dlabs Graphics Accelerator Card User's Guide
Copyright 2002 by 3Dlabs, Inc.
3Dlabs is a registered trademark, and Wildcat, SuperScene, ParaScale and DirectBurst are trademarks of
3Dlabs, Inc. or 3Dlabs Inc. Ltd. Pentium is a registered trademark of Intel. OpenGL is a registered
trademark of Silicon Graphics, Inc. Soft Engine is a trademark of Vibrant Graphics, Inc. AutoCAD is a
registered trademark of AutoDesk Inc. Microsoft, Windows NT, Windows 2000, and Windows XP are
registered trademarks of the Microsoft Corporation. Athlon and 3DNow! are registered trademarks of
AMD. All other trademarks and registered trademarks are the property of their respective holders.
Caution: Changes or modifications to your 3Dlabs Graphics Accelerator Card not expressly approved by
3Dlabs, Inc. voids the user’s warranty.
FCC Notice: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy. If product is not installed and used in accordance with the instruction Guide, it
may cause harmful interference to radio communications; however, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
1. Re-orient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
4. Consult 3Dlabs or an experienced radio/TV technician for assistance.
Compliance with FCC Rules requires that a shielded cable be used to connect to other equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1)
this device may not cause harmful interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
This Class B digital apparatus meets all the requirements of the Canadian Interference- Causing
Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du
Règlement sur le material brouilleur du Canada.
3Dlabs, Inc. makes no representation that the use of its products in the manner described in this
publication will not infringe on existing or future patent rights, nor do descriptions contained in this
publication imply the granting of licenses to make, use, or sell equipment or software in accordance with
the description.
Specifications Subject to Change Without Notice
P/N 61-000057