3DLABS Wildcat III 6110 - Manual (Page 38)

Troubleshooting
3Dlabs Graphics Accelerator Card User's Guide
Reinstalling the video driver
1. Log on using an account that has administrative privileges.
2. From the operating system Start menu in Windows NT and Windows 2000, go to Settings,
Control Panel, System. In Windows XP, go to Start, Control Panel, Performance and
Maintenance, System
3. Under System, click the Hardware tab.
4. Click Device Manager, click Display Adapters, then select Wildcat III 6210 or Wildcat III
6110.
5. Right click on Wildcat III 6210 or Wildcat III 6110, select Properties, then click Update
Driver.
6. The Upgrade Device Drivers Wizard displays. Click Next.
7. Under Install Hardware Device Drivers, click “Search for a suitable driver for my device
(recommended),” then click Next.
8. Under Locate Driver Files, make sure the appropriate search location is selected, and that
Disk 1 of the driver media is loaded in the appropriate drive; then, click Next. The Wizard
locates the driver installation files
9. Under Driver Files Search Results, click Next to start the installation.
10. Insert Disk 2 when prompted then click OK to continue with the installation.
11. Once the driver successfully installs, click Finish to dismiss the Install Hardware Device
Drivers Wizard.
12. Remove the delivery media from the disk drive and restart the workstation.
Online Information
If you cannot find the problem you are experiencing, or the solution to a problem, listed in this chapter,
check the Troubleshooting section of the 3Dlabs web site at:
http://www.3dlabs.com/support/troubleshooting/index.htm, or contact your vendor for additional help.