3DLABS Wildcat 4110 - Manual (Page 14)

8
Installing the Video Card
Refer to your computer’s documentation for instructions on opening and closing the computer, identifying
the AGP Pro expansion slot, PCI expansion slots, and adding expansion cards.
To install the 3Dlabs Wildcat 4110 PRO video card:
1. Turn off power to the computer and to the monitor, and disconnect the cables from the
computer.
2. Open the computer to gain access to the AGP Pro expansion slot.
3. Remove the existing card. Keep the screws; you will use them to secure the 3Dlabs
Wildcat 4110 PRO card to the chassis.
4. Align the Wildcat 4110 PRO card with the AGP Pro expansion slot. Make sure the gold-
fingered connections on the card's edge are aligned properly with the slot connector (see
Figure 2; these connectors are labeled on the left side of the image).
Figure 2. Wildcat 4110 PRO Video Card
5. Push the card into the expansion slot firmly and evenly until it is fully seated in the slot
connector.
6. Visually inspect the connection. If it does not appear to be correct, remove and reinstall
the card.
7. Use the screws you removed previously to secure the card to the computer’s chassis.
8. Close the workstation and reconnect the power cord. See “Connecting the Monitor” in
this chapter for instructions on connecting a display device to the Wildcat 4110 PRO
video card.