3DLABS Wildcat 4110 - Manual (Page 27)

21
5. Reboot the workstation if you are prompted to do so. Most changes will take effect
without rebooting.
NOTE: See Appendix A, “Specifications,” for a list of available monitor resolutions.
NOTE: See “Enabling Stereo Display,” in this chapter for instructions on changing the Display Mode.
Enabling Stereo Display
If you connect a device to the stereo port on the Wildcat 4110 PRO card, you must change the display
mode to view in stereo. See Figure 2 in Chapter 2, “Setup,” for an illustration of the stereo output port.
NOTE: The Display Properties dialog box must be displayed. See “Configuring the Video Display” in
this chapter for instructions on activating the Display Properties dialog box and selecting the
3Dlabs Monitor tab.
To enable stereo display:
1. Make sure your stereo display device is properly connected to the stereo output port on
the Wildcat 4110 PRO card. See Chapter 2, “Setup,” for more information.
2. On the Wildcat Monitor tab under Display Properties, click Configure Monitor. The
Configure Monitor dialog box displays (see Figure 9, above).
3. Select one of the Stereoscopic Display modes from the Display Mode pulldown, then
click OK. You are returned to the Display Properties dialog box.
4. If you are prompted with the following message: “The selected monitor cannot display
the current desktop area. Select a new resolution before applying these changes,” click
OK then select a resolution from the list of available resolutions.
5. Click OK if the display is correct and you wish to keep the new settings. The Display
Properties dialog box is dismissed.
6. Click OK to accept the new display mode and dismiss the Display Properties dialog box.
NOTE: You must disable stereo mode when you no longer wish to view in stereo. Follow the steps
above, and select Monoscopic Display under Display Mode to disable stereo mode.