3DLABS Wildcat 4110 - Manual (Page 16)

10
Installing the Software
If you received your 3Dlabs Wildcat 4110 PRO video card with a system, the graphics drivers were
installed prior to shipment. This section only applies if you purchased your 3Dlabs Wildcat 4110 PRO
video card as an upgrade, or if you are reinstalling the driver.
Make Sure Your Computer is Ready
Make sure your workstation has the following before installing Wildcat driver software:
♦ Microsoft Windows NT Workstation 4.0 with Service Pack 5 (or later) or Windows 2000
operating system software installed
♦ 3MB of free space on the computer’s primary system disk
CAUTION: You must have the correct driver for the Windows NT 4.0 or Windows 2000 operating
system. If you are unsure, refer to the README . TXT file located on the driver delivery
media for this information.
NOTE: Refer to the Microsoft Windows NT or Windows 2000 documentation and online Help for more
information on installing drivers and software application programs.
NOTE: If you are reinstalling the 3Dlabs Wildcat 4110 PRO driver, you must remove the current driver
prior to installing the update.
If you’re running Windows NT 4.0
To remove the existing 3Dlabs Wildcat 4110 PRO driver:
1. Log on using an account that has administrative privileges.
2. From the operating system Start menu, go to Settings/Control Panel and double-click
Add/Remove Programs.
3. On the Add/Remove Programs Properties Install/Uninstall tab, highlight the 3Dlabs
Display Driver and click Add/Remove.
4. Click Yes when prompted to confirm the driver removal, and follow the prompts. Reboot
the system before installing the Wildcat 4110 PRO driver.
To install the Wildcat 4110 PRO video driver:
1. Log on using an account that has administrative privileges.
2. Insert the delivery media into the appropriate device (for diskettes or CD).
3. From the operating system Start menu, go to Settings/Control Panel/Display and click the
Settings tab.
4. Click Display Type, then click Change.