3DLABS Wildcat 4110 - Manual (Page 24)

18
3 Using the Video Card
This chapter contains instructions for configuring the video display and enabling the stereo display.
NOTE: If you ordered this video card with a system, it was configured for use prior to shipment. The
following instructions apply only if you purchased the card as an upgrade or add-on.
Configuring the Video Display
Once the drivers are installed properly, the Display Properties dialog box will have two additional tabs:
3Dlabs Configuration and 3Dlabs Monitor.
Wildcat Configuration Tab
To use the Wildcat Configuration tab:
1. Make sure you are logged into the non-VGA version of Windows NT 4.0 or Windows
2000. Refer to Windows NT 4.0 or Windows 2000 documentation or online Help for
instructions, if necessary.
2. Close any open applications.
3. From the operating system Start menu, go to Settings/Control Panel/Display. In Windows
NT 4.0, click the 3Dlabs Configuration tab if it is not already displayed. In Windows
2000 follow the same path; then click the Settings tab and then Advanced. Click the
3Dlabs Configuration tab if it is not already displayed (see Figure 6).
4. On the Wildcat Configuration tab:
−
Click Hardware Info to view the current hardware settings.
−
Click View Config to view your current display configuration.
−
Click Config Wizard to activate a step-by-step interface that will help you modify
your current display configuration or create a new one. On the Wildcat Configuration
Wizard, click Next and follow the prompts to create a new configuration, or modify
or delete an existing one.