ADLINK PCIe-7200 - Manual (Page 36)

Register Format 27
3.5 Interrupt Status & Control Register (BASE + 1C)
The interrupt mode/status is set/checked through this register.
Address: BASE + 1C
Attribute: READ/WRITE
Data Format:
 Interrupt Control:
With the 7200 series, interrupts can be triggered by many
signal sources such as O_ACK, I_REQ, timer 0, timer 1, and
timer 2. The following bits control the interrupt source:
IO_ACK: Interrupt is triggered by O_ACK signal.
1: O_ACK interrupt is enabled
0: O_ACK interrupt is disabled
II_REQ: Interrupt is triggered by I_REQ signal.
1: I_REQ interrupt is enabled
0: I_REQ interrupt is disabled
T0_EN: Interrupt is triggered by timer 0 output.
1: Timer 0 interrupt is enabled
0: Timer 0 interrupt is disabled
T1_EN: Interrupt is triggered by timer 1 output.
1: Timer 1 interrupt is enabled
0: Timer 1 interrupt is disabled
T2_EN: Interrupt is triggered by timer 2 output.
1: Timer 2 interrupt is enabled
0: Timer 2 interrupt is disabled
 Interrupt Status:
Byte 7 6 5 4 3 2 1 0
Base +1C SI_TO SI_REQ SO_ACK T2_EN T1_EN T0_EN II_REQ IO_ACK
Base +1D FIFOFF FIFOEF FIFORST REQ_NEG T1_T2 T0_T2 SI_T2 SI_T1
Base +1E ---- ---- ---- ---- ---- ---- ---- ----
Base +1F ---- ---- ---- ---- ---- ---- ---- ----