ADLINK PCI-7200 - Manual (Page 39)

Register Format 27
I_REQ: Input REQ Strobe Enabled
1: Use I_REQ edge to latch input data
0: I_REQ is disabled
I_TIME0: Input Timer 0 Enable
1: Input is sampled by falling edge of Counter 0 output
(COUT0)
0: Input Timer 0 is disabled
I_FIFO: Input FIFO Enable Mode
1: Input FIFO is enabled (input data is saved to input FIFO)
0: Input FIFO is disabled
TRGPOL: Input Trigger Polarity
1: I_TRG is Rising Edge Active
0: I_TRG is Falling Edge Active
I_TRG: External Trigger Enable
1: Wait until I_TRG signal is active, digital input sampling will
begin after a rising or falling edge of I_TRG
0: Start input sampling immediately (if input control register
is set)
DIN_EN: Digital Input Enable
1: Digital Input Enable
0: Digital Input Disabled, when this bit is set as 0, all digital
input operation will be stopped
X
Digital Output Mode Setting:
O_ACK: Output ACK Enable
1: Output ACK is enabled; the output circuit will wait for
O_ACK after O_REQ strobe is asserted
0: Output ACK is disabled
O_REQ: Output REQ Enable
1: Output REQ is enabled; an O_REQ strobe will be gener-
ated after output data is ready
0: Output REQ is disabled
O_TIME1: Output Timer 1 Enable
1: Output Timer 1 is enabled; output data is moved from out-