ADLINK PCI-7200 - Manual (Page 43)

Register Format 31
clock input.
X
I_REQ Polarity Selection:
When the input sampling is controlled by the I_REQ signal
only, the I_REQ can be programmed to be rising edge active
or falling edge active.
REQ_NEG: I_REQ trigger polarity
1: latch input data on falling edge of I_REQ
0: latch input data on rising edge of I_REQ
X FIFO Control and Status (cPCI-7200 only):
The cPCI-7200 has an extra 2k samples digital input FIFO.
The FIFO can be cleared and monitored by the following bits:
FIFORST (Write only): Clear the on-board DI FIFO
1: Write 1 to clear the data of the FIFO.
0: No operation.
FIFOEF (Read only): Empty flag of the DI FIFO
1: DI FIFO is empty.
0: DI FIFO is not empty.
FIFOFF (Read only): Full flag of the DI FIFO
1: DI FIFO is full.
0: DI FIFO is not full.
Note: The cPCI-7200 has two cascaded DI FIFOs. One is located
in the PCI controller chip, the other one is on the PCI-7200
board. The above bits only control the onboard FIFO. In or-
der to control the on-chip FIFO, please refer to the AMCC-
5933 data book.