ADLINK cPCI-7300 - Manual (Page 16)

8
• Installation
2.2 Unpacking
Your cPCI/PCI-7300A card contains sensitive electronic components that can
be easily damaged by static electricity.
The card should be placed on a grounded anti-static mat. The operator should
be wearing an anti -static wristband, grounded at the same point as the
anti-static mat.
Inspect the card module carton for obvious damage. Shipping and handling
may caus e damage to your module. Be sure there are no shipping and
handling damages on the module before processing.
After opening the card module carton, extract the system module and place it
only on a grounded anti -static surface component side up.
Again inspect the module for damage. Press down on all the socketed IC's to
make sure that they are properly seated. Do this only with the module place on
a firm flat surface.
Note: DO NOT APPLY POWER TO THE CARD IF IT HAS BEEN
DAMAGED.
You are now ready to install your cPCI/PCI-7300A.
2.3 Device Installation for Windows Systems
Once Windows 95/98/2000 has started, the Plug and Play function of Windows
system will find the new NuDAQ/NuIPC cards. If this is the first time to install
NuDAQ/NuIPC cards in your Windows system , you will be informed to input
the device information source. Please refer to the “Software Installation
Guide” for the steps of installing the device.