ADLINK PXIS-2630 Series - Manual (Page 37)

Pin Assignments • 31
Note 1: Pin #8, #9, and #18 are not standard ATX power definition.
General Purpose screw terminals
Position Signal Name
J4 +3.3V
J6 V(I/O)
J7 +5V
Note that the V(I/O) must be shorted to either +3.3V or +5V. The default factory
setting is to short V(I/O) to +5V.
J3 INH#: DC power inhibit signal
Pin # Signal Name
1 INH#
J3
2 GND
J2 PRST#: System reset signal
Pin # Signal Name
1 RST#
J2
2 GND
J1 FAL#: Power supply fail input
Pin # Signal Name
1 FAL#
J1
2 GND
J8: Connector for LED power status
Name Pin # Pin # Name
GND 8 7 +3.3V
GND 6 5 +5V
GND 4 3 -12V
J8
GND 2 1 +12V
J5: SMB (system managing bus) connector
Pin # Name
1 SMCLK
2 GND
J5
3 SMDATA