Desa (V)T32N SERIES - Manual (Page 28)

www.desatech.com 111986-01D 8
OPERATING FIREPLACE
Continued
MANUAL LIGHTING
pROCEDURE
1. Remove glass door (see Removing/Replacing
Glass Door, page 24.)
2. Follow steps 1 through 7 under Lighting
Instructions, page 27.
3. Depress gas control knob and light pilot
with match.
4. Keep gas control knob pressed in for 30
seconds after lighting pilot. After 30 sec-
onds, release gas control knob. Follow steps
9 through 12 under Lighting Instructions,
page 27.
5. Replace glass door (see Removing/Replacing
Glass Door, page 24).
OpTIONAL HAND-HELD
REMOTE OpERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page
36). Follow instructions included with the
remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 27.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 51). Note:
The burner may light if hand-held remote was
on when selector switch was last turned off.
You can now turn the burner on and off with
the hand-held remote control unit.
OF
F PIL
O
T
LO
IH
ON OFF REMOTE
ON
OFF
O N
Selector Switch in
Remote Position
Figure 51 - Setting the Selector Switch,
Gas Control Knob and Variable Contorl
Knob for Remote Operation
Blower Control Knob
(Optional Accessory)
Gas Control Knob in
ON Position
Variable
Control Knob
Figure 52 - On/Off Hand-Held Remote
Control Unit HRC100
Control
Button
Indicator
Light
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
ON/OFF SERIES
(MODELS HRC100 AND HRC101)
Hold the control button on the hand-held
remote until burner turns on. Hold the con-
trol button again until burner turns off (see
Figure 52).
TO LOCK
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK
press both buttons together on
hand-held remote control until the light stops
flashing. The hand-held remote is now unlocked.
THERMOSTAT SERIES
(MODEL HRC200 AND HRC201)
The hand-held remote can be operated using
either the manual mode (MANU) or thermostatic
mode (AUTO) (see Figure 53, page 30). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
fireplace.
3. Press the POWER and LOCK buttons
together to turn off the fireplace.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press AUTO button to select this mode.
3. Set the desired room temperature by press-
ing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the fireplace