ADLINK nanoX-TCR - Manual (Page 5)

nanoX-TCR Reference Manual 1
Chapter 1 About This Manual
Purpose of this Manual
This manual is for designers of systems based on the nanoX-TCR (Computer-on-Module). This manual
contains information that permits designers to create an embedded system based on specific design
requirements.
Information provided in this reference manual includes:
• nanoX-TCR specifications
• Environmental requirements
• Major ICs and features implemented
• nanoX-TCR connector/pin numbers and definitions
• BIOS Setup information
Information not provided in this reference manual includes:
• Detailed chip specifications
• Internal component operation
• Internal registers or signal operations
• Bus or signal timing for industry-standard busses and signals
References
The following list of references may be helpful for you to complete your custom design successfully.
Specifications
• COM Express Specification Revision 2.0
Web site: http://www.picmg.org/
• COM Express Carrier Design Guide 1.0
Web site: http://www.picmg.org/pdf/PICMG_COMDG_100.pdf
• LPC Bus Specification, Revision 1.1, August, 2002
Specification: http://www.intel.com/design/chipsets/industry/25128901.pdf
• PCIe Specification, Revision 1.0a, April 15, 2003
Specification (for members): http://www.pcisig.com/home
• I 2 C Bus Specification Version 2.1
Specification: http://www.nxp.com/documents/other/39340011.pdf
• AMI BIOS Aptio TSE User’s Guide
Datasheet: http://www.ami.com/support/doc/AMI_TSE_User_Manual_PUB.pdf
• Bosch CAN specification version 2.0B
Specification: http://www.can-cia.org/fileadmin/cia/specifications/CAN20B.pdf
• SATA Specification Version 2.6
Web site: http://www.sata-io.org/