ADLINK nanoX-BASE - Manual (Page 30)

nanoX-BASE User’s Manual Page 30
CN38: Carrier GPIO
GPIOs of CN38 come from
the NXP PCA9535 I/O Port
onboard the nanoX-BASE
(enabled/disabled by JP19).
Pin Signal Pin Signal
1 GPI0 2 GPO0
3 GPI1 4 GPO1
5 GPI2 6 GPO2
7 GPI3 8 GPO3
1 2
7 8
S1: Carrier GPIO Address
SD Card Enable Switch
Default: all "On".
Pin On Off Description
1 Low High GPIO address A0
2 Low High GPIO address A1
3 Low High GPIO address A2
4 Enabled Disabled SD card enable
6.21 GPIO
1 2 3 4
ON DIP
CN39: Module GPIO
GPIOs of CN39 come from
the COM Express module.
Pin Signal Pin Signal
1 GPI0 2 GPO0
3 GPI1 4 GPO1
5 GPI2 6 GPO2
7 GPI3 8 GPO3
1 2
7 8
Pins 1-3 of the S1 switch set the device address of the NXP PCA9535 I/O Port.
R/W 0 1 0 0 A2 A1 A0
programmable
slave address
fixed
JP19: Onboard GPIO
Enables/disables the GPIO onboard
the nanoX-BASE carrier.
Jumper Status
1-2 Enable <<<<
2-3 Disable
1
2
3
Note: <<<< indicates default setting