ADLINK nanoX-BASE - Manual (Page 33)

Page 33 nanoX-BASE User’s Manual
JP1: ATX/AT Mode
In AT mode, JP1 shorts PS_ON# to
ground directly to force power on.
Jumper Status
1-2 ATX mode <<<<
2-3 AT mode
1
2
3
JPX2: AT Power 5V Setting
With an AT power supply is connected to
the nanoX-BASE, JPX2 can be used to
provide 5VSB to the COM module from
the carrier board.
Jumper Status
1-2 AT without P5V <<<<
2-3 AT with P5V
1
2
3
JP21: PS_ON# Signal Source
Jumper Status
1-2 SUS_S3# <<<<
2-3 SUS_S5#
All ADLINK modules support S3 mode and use
the SUS_S3# signal to control the PS_ON#
signal which is used to turn the ATX power
supply on and off. This jumper should be set to
SUS_S3# as signal source to allow normal
operation (even when S3 mode is disabled in
the BIOS). To accomodate non-standard
designs that use SUS_S5# as the signal source
to control PS_ON#, set the jumper to SUS_S5#.
Note: <<<< indicates default setting
1
2
3
6.24 Power Jumper Settings