ADLINK MXE-1300 Series - Manual (Page 31)

Introduction 19
MXE-1300
1.8.1 SATA Slot
The MXE-1300 provides a Gen 2 SATA port at 3.0 Gbit/s, compat-
ible with SATA Gen 1 1.5Gbit/s. The SATA host controller sup-
ports legacy mode using I/O space and AHCI mode using memory
space. This SATA connector accepts 2.5” and 3.5” (optional) HDD
or solid state disk (SSD). The disk must be installed in the SATA
connector with a HDD bracket. For installation information, see
“Installing a Hard Disk Drive” on page 25.
1.8.2 LVDS Interface Connector (optional)
The MXE-1300 provides an internal LVDS interface connector,
supporting single channel up to 1366*768 24-bit resolution, with
pin numbering and definition as follows.
Figure 1-14: LVDS Pin Numbering
1 2