ADLINK NuPRO-E330 - Manual (Page 49)

Driver Installation 35
NuPRO-E330
4 Driver Installation
This chapter provides information on how to install the
NuPRO-E330 device drivers under Windows XP. The device
drivers are located in the following ADLINK All-in-One DVD
directories:
Install the Windows operating system before installing any driver.
Most standard I/O device drivers are installed during Windows
installation.
4.1 Intel® Rapid Storage Technology Driver
1. Create a floppy image as described in the F6Readme.txt file
contained in X:\NuPRO\NuPRO-E330\Others\
F6_SATA_Floppy_Install_Image_WinXP32_WinVISTA32_
IRST 9.5.0.1037.zip.
2. During Windows installation, press F6 when you see the
message “Press F6 if you need to install a third party
SCSI or RAID driver.” Then press S to Specify Additional
Device.
3. Insert the floppy disk and follow the remaining instruc-
tions. Leave the disk in until the system has rebooted
and copied the necessary files, then remove the disk.
Chipset \NuPRO\NuPRO-E330\Chipset\
Display \NuPRO\NuPRO-E330\VGA\
\Add-On Card\mPCIe-8770\
Ethernet \NuPRO\NuPRO-E330\Ethernet\
TPM \NuPRO\NuPRO-E330\TPM\
.Net Framework \NuPRO\NuPRO-E330\Others\
Rapid Storage \NuPRO\NuPRO-E330\Others\
iAMT \NuPRO\NuPRO-E330\Others\
Audio \Audio Daughter Board\DB-Audio2\
NOTE: NOTE:
In order to enable RAID or AHCI mode, you must pre-install the
Intel® Rapid Storage Technology driver during the Windows*
installation process. using the F6 installation method.
*Not required for Windows Vista and Windows 7.