ADLINK CM1-86DX2 - Manual (Page 11)

Introduction 5
CM1-86DX2
1.5 Specifications
Electrical Specifications
Environmental Specifications
Table 1-3: Electrical Specifications
Supply voltage: +5 V DC
+5 V standby (only needed for suspend mode)
+12 V (only needed for LVDS display and expansion
slots)
Rise time:
< 10 ms
Supply voltage tolerance:
± 5%
Inrush current:
1.6 A
Supply current: max. 1.7 A (Windows XP, PIcalc [lots of decimals of
PI]) ; typical 1.5A
Table 1-4: Operating
Temperature range 0°C … 60°C (standard version)
-20°C … 60°C (industrial version)
-40°C … 85°C (extended version)
Temperature change max. 10 Kelvin per 30 minutes
Humidity (relative)
10 % … 90 % (non-condensing)
Pressure
450 hPa … 1100 hPa
Table 1-5: Non-Operating/Storage/Transport
Temperature range
-40°C … 85°C
Temperature change max. 10 Kelvin per 30 minutes
Humidity (relative) 5 % … 95 % (non-condensing)
Pressure 450 hPa … 1100 hPa
Table 1-6: HALT Parameters
Cold Temperature Step Stress
The board remained operational during test down to
-100°C, starting at +20°C and decreasing in 10°C
increments with 15 minute dwells
Hot Temperature Step Stress The board remained operational during test up to
+90°C, starting at +30°C and increasing in 10°C incre-
ments with 15 minute dwells
Rapid Thermal Transitions The board was subject to five rapid temperature cycles
from -90°C to +85°C @ set transition rate of 60°C per
minute