ADLINK CM1-86DX2 - Manual (Page 25)

Module Description 19
CM1-86DX2
VGA Header (X8)
Connector type: DC10 pin header 2.54 mm
Adapter cable: Article number 862-0008-11
LVDS Configuration
The onboard voltage jumper headers allow you to select the display and backlight supply volt-
ages. (See Table 3-4 on page 23 for Display and Backlight Voltage jumper signals.)
LVDS support can be configured within the BIOS. Using LVDS disables the VGA port on the
CM1-86DX2. You can use a CRT or an LVDS panel only exclusively from each other.
Table 3-1: VGA Header Signals (X8)
Pin Signal Pin Signal
1 Red 2 GND
3 Green 4 GND
5 Blue 6 VGA_DDC_CLK
7 HSYNC 8 VGA_DDC_DATA
9 VSYNC 10 GND
You can switch the video output at startup by pressing the “c”-Key for CRT-mode and
the “t”-Key for LVDS-mode.