ADLINK Hurricane-QM57 - Manual (Page 25)

TME-EPIC-HURQM-R2V9 Revision 2.9 Page 19 of 74
The display options of LVDS are shown in the table:
Setting Possible Values
Flat Panel Type LVDS
Resolution 640x480, 800x600, 1024x768, 1280x1024, 1400x1050,
1600x1200, 1200x768, 1600x1050, 1920x1200
Data Bus Type 18/24 Bits, 2ppc
Refresh Rate 60 70, 72, 75, 85, 90, 100 Hz
HSYNC Polarity High, Low
VSYNC Polarity High, Low
LP Active Period Active Only  only active during SYNC
Free Running  always active
SHFCLK Active Period Active Only  only active during SYNC
Free Running  always active
To ease usage of these displays it’s possible to select the display and backlight supply voltages with the
onboard voltage selector jumpers. (Jumper LVDS and Backlight, see below)
LVDS Connector (X27)
Connector type: DF14-30P-1.25H (Hirose)
Pin Signal
1 VDD (3.3 V, opt.5 V)
2 VDD (3.3 V, opt.5 V)
3 GND
4 GND
5 TXA3 -
6 TXA3 +
7 TXACLK -
8 TXACLK +
9 GND
10 TXA2 -
11 TXA2 +
12 TXA1 -
13 TXA1 +
14 TXA0 -
15 TXA0 +
16 GND
17 TXB3 -
18 TXB3 +
19 TXBCLK -
20 TXBCLK +