ADLINK Hurricane-QM57 - Manual (Page 32)

TME-EPIC-HURQM-R2V9 Revision 2.9 Page 26 of 74
The Hurricane-QM57 uses a codec from Realtek. The ALC888 is a high-performance 7.1+2 Channel High
Definition Audio Codec.
The following I/O's are used by the Hurricane-QM57:
 Analog Input (All ADC support 44,1k/48k/96kHz sampling rate)
o
Microphone left and right
o
Line In left and right
 Analog output (All DAC support 44,1k/48k/96/192kHz sampling rate)
o
Front left and right
o
Rear left and right
o
Center and Subwoofer
 Digital input (16/20/24-bit S/PDIF-in support 44,1k/48k/96/192kHz sampling rate)
o
S/PDIF
 Digital output (16/20/24-bit S/PDIF-out support 44,1k/48k/96/192kHz sampling rate)
o
S/PDIF
Audio Connector (X10)
Connector type: IDC16 pin header 2.00 mm
Adapter cable: available, part.no. 862-0065-10
Pin Signal Pin Signal
1 Line-Out R 2 Line-Out L
3 Surrond R 4 Surrond L
5 LFE 6 Center
7 GND-Audio 8 GND-Audio
9 Line-In R 10 Line-In L
11 Mic R 12 Mic L
13 GND 14 GND
15 S/P-Dif IN 16 S/P-Dif OUT
3.8
PCI/104-Express Bus Interface
The PCI Express architecture uses familiar software and configuration interfaces of the conventional PCI bus
architecture, but provides a new high-performance physical interface while retaining software compatibility with
the existing conventional PCI infrastructure.
PCI Express is a high performance I/O architecture used in both desktop and mobile applications. This
hierarchical, point-to-point interconnect works well with on-board and slot oriented architectures. The purpose
of this Specification is to adapt PCI Express to the stacked architecture employed with 104, EPIC and EBX form
factor.