Dream Property DM8000 HD PVR - Manual (Page 51)

-51-
11.4 A/V Settings
If no OSD menu is visible on your screen, press the Menu-Button to open the main OSD menu. Navigate to
the option “Setup” and press the OK-Button to select.
1. Navigate to the option “System” and press the OK-Button.
• The “System” menu will open up.
2. Navigate to the option “A/V settings…” and press the OK-Button.
Video output:
This option selects to which output the video signal will be sent to.
DVI
If you have connected your TV to the DVI output of your Dreambox set the “Output type” option to DVI.
YPbPr
If you have connected your TV to the YPbPr output (component cable) of your Dreambox set the “Output
type” option to YPbPr.
Scart
If you have connected your TV to the Scart output of your Dreambox set the “Output type” option to Scart.
Mode:
Use the Navigation-Buttons left/right to select the desired screen resolution. This option is only available for
the output types DVI an YPbPr.
Refresh Rate: (This option is only available for the output types DVI an YPbPr)
Select the refresh rate supported by your TV screen. This si either 50Hz or 60Hz.
Display 4:3 content as:
Pillarbox
4:3 shows will be shown in full height on a 16:9 screen and you will have black bars on both sides.
Pan&Scan
4:3 shows will be shown in full width on a 16:9 screen and a bit will be cut off on the top and bottom.
Just Scale
4:3 shows will be shown in full height on a 16:9 screen and are stretched to fit the width of your screen.
Nonlinear
Only the outer parts of the picture are stretched to prevent the center from being distorted. You will still
have a full screen picture.