Dream Property DM7025 + - Manual (Page 12)

- 12 -
U s e r M a n u a l D r e a m b o x D M 7 0 2 5 / D M 7 0 2 5 +
1.3.2
Explanation rear panel
Mains switch
The main power switch completely cuts power from your Dreambox.
Mains connection
Plug the power cable into the main power socket. You must not connect the power plug to
anything other than a socket that supplies 110V/60Hz or 230V/50Hz.
Analog audio out (RCA)
Connect your Dreambox with a RCA/Cinch cable to your HiFi-Amplifier (e.g. AUX In or Tape
In ports).
Video out (Composite)
You can optionally connect your Dreambox to a TV using a RCA/Chinch cable.
TV Scart
Connect your TV, projector or beamer to your Dreambox using a Scart cable
VCR Scart
Connect your VCR or DVD player to your Dreambox using a Scart cable. Remember, the
VCR Scart is not designed to record a video signal from the VCR or DVD player. The signal
of the connected device is looped through to the TV-Scart connector, incase you have
selected VCR Scart in the main menu. Note: You cannot record any signals onto your
Dreambox using this connector.
UHF Modulator
You can optionally connect your Dreambox to your TV via a coaxial cable.
Network interface (Ethernet 10/100Mbit, RJ45)
The Communication Port is an Ethernet port. It is used to communicate with your Dreambox
via HTTP, FTP, NFS, Telnet and Samba to access your recorded movies, to upload channel
lists, etc. This port is also used to update the operating system of your Dreambox. Please
use a regular patch cable to connect your Dreambox to your LAN.
USB port
The USB Port is designed for devices that support the USB 1.1 standard. The amount of
supported USB devices depends on the installed image (Software) and is still under
development.