Dream Property DM7020 HD - Manual (Page 45)

5.2 Management
1. Press the Menu-Button to open the main OSD menu.
2. With the Navigation-Buttons ( ) choose the option “Setup” and press the OK-Button.
3. With the Navigation-Buttons ( ) choose the option “System” and press the OK-Button.
4. With the Navigation-Buttons ( ) choose the option “Harddisk” and press the OK-Button.
5. With the Navigation-Buttons ( ) choose the option “Harddisk setup” and press the OK-Button.
You now can set the duration of time after which the harddisk will be put into standby-mode. You can
select from:
• No standby
• 10 or 30 Seconds
• 1, 2, 5, 10, 20 or 30 Minutes
• 1, 2 or 4 Hours
Once you have selected the desired time press the OK-Button or the green Options-Button to get back
into the harddisk menu.
5.2.1 Initialization
1. Press the Menu-Button to open the main OSD menu.
2. With the Navigation-Buttons ( ) choose the option “Setup” and press the OK-Button.
3. With the Navigation-Buttons ( ) choose the option “System” and press the OK-Button.
4. With the Navigation-Buttons ( ) choose the option “Harddisk” and press the OK-Button.
5. With the Navigation-Buttons ( ) choose the option “Initialization” and press the OK-Button.
6. With the Navigation-Buttons ( ) choose the option “ST3500820AS - Internal (488.395 GB)”
and press the OK-Button. If you have installed another hard disk this option will differ from the
one depicted!
7. By pressing the red Options-Button you will initialize (format) the hard disk. After you confirm
the safety question the initialization process starts.
!!! WARNING !!! All data stored on the HDD will be lost.
40