Dream Property DM7020 HD - Manual (Page 64)

7. With the Navigation-Buttons ( ) choose the option “Single”.
8. With the Navigation-Buttons ( ) choose the option“Satellite”.
9. With the Navigation-Buttons ( ) choose the desired Satellite.
10. Press the OK-Button to save this settings.
You are taken back to the “Choose tuner” menu.
If you have trouble with “Tune failed” messages please set the “Send DiSEqC only on sattelite
change”
to “yes”.
7.1.2 Two satellites via Toneburst A/B
Use this type of configuration if you want to receive two satellites from one LNB each. It does not matter
if you use one or two dishes to achieve this. Connect the two coax cables form the two LNBs to a so-called
Toneburst switch and connect the coax cable from the Toneburst switch to your Dreambox.
Two satellites via Toneburst
Follow this steps:
1. Press the Menu-Button to open the main OSD menu.
2. With the Navigation-Buttons ( ) choose the option “Setup” and press the OK-Button.
3. With the Navigation-Buttons ( ) choose the option “Service searching” and press the OK-
Button
.
4. With the Navigation-Buttons ( ) choose the option “Tuner configuration” and press the OK-
Button
.
5. With the Navigation-Buttons ( ) choose the option “DVB-S2 Tuner” and press the OK-Button.
6. With the Navigation-Buttons ( ) choose the option “Mode”.
7. With the Navigation-Buttons ( ) choose the option “Toneburst A/B”.
8. With the Navigation-Buttons ( ) choose the option “Port A”.
59