Echelon LonTal Stack - Manual (Page 234)

222 Appendix H: Appendix H
LonTalk Interface Developer Utility Error and
Warning Messages
LID# Description
10 Failure to attach to LONUCL32 service DLL
The LonTalk Interface Developer utility or one of its components
failed to locate a file by name of “LONUCL32.DLL.” This file usually
resides in the same folder that contains the LID.exe application, but
can be in any folder in your current user search path. This file is
typically installed into the LonWorks Bin folder.
18 An error occurred when composing the application XIF file: the data
merge target is ill-chosen (must be the BIF file)
This is an internal error that should not normally occur. However, it
could be a result of an earlier failure. For example, a non-fatal error
during the creation of the device interface file might lead to this
error. Re-run the LonTalk Interface Developer utility in Trace
verbosity mode and carefully examine the LonTalk Interface
Developer utility Summary window to determine the root cause of
the failure.
19 File I/O error when writing XIF file
Refer to the error message for details about the failure cause. The
error message contains details such as “disk full,” or “file access
denied”.
20 Error (non-file I/O) when writing XIF file
Refer to the error message for details about the failure cause. The
error message contains details such as “disk full,” or “file access
denied”.
21 The xif32bin.exe utility returned an error, indicating failure when
converting XIF to XFB
The binary device interface file (.xfb extension) could not be created.
Make sure a previously existing binary device interface file is not
write-protected. Also make sure the XIF32Bin.exe utility, which is
used to create the binary device interface file, is available in a folder
that is part of the system or current user search path. By default,
the utility can be found in your L
ON
W
ORKS
Bin folder.
22 An error occurred when reading a type info file (.NCT)
This is an internal error, possibly resulting from an earlier failure.
The .nct file is an intermediate file used by the ShortStack Wizard.
Re-run the LonTalk Interface Developer utility in Trace verbosity
mode and carefully examine the LonTalk Interface Developer utility
Summary window to determine the root cause of the failure.