Project 336 delay lamp, Project 337 adjustable delay lamp – Elenco Snap Circuits® Deluxe Sound & Light Combo User Manual

Page 144

Advertising
background image

-143-

Project 334

Adjustable Timer Tone

Project 335

Photo Timer

Tone

Note that there is a 3-snap wire

under Q2, partially hidden. Turn

on both slide switches (S1) and

push the press switch (S2). You

hear a tone, which turns off after

a while. Push S2 again to restart

the keyboard and its timer. Use

the adjustable resistor (RV) to set

how long the timer keeps the

sound on for, it can be set for a

few seconds or very long. You

can change the tone that plays by

pressing keys on the keyboard

(U26).
Turning off the left slide switch

turns off the tone, but not the keys

or timer.

Use the preceding circuit, but replace

the 5.1kW resistor (R3) with the

photoresistor (RP). The circuit works

the same way, but you can vary the

pitch of the tone by adjusting the

amount of light on the photoresistor.

Project 337

Adjustable

Delay Lamp

Use the preceding circuit, but replace

adjustable resistor (RV) with the

500kW adjustable resistor (RV3). Set

the knob on RV3 to different positions,

press S2 to start the timer, and see

how long it takes for the color LED to

turn on. Turning RV3’s knob clockwise

gives longer delay, turning counter

clockwise gives shorter delay.

Project 336

Delay Lamp

Push and release the press switch (S2), then turn on the

slide switch (S1). Nothing happens at first, but after a few

seconds the color LED (D8) turns on. Press S2 to turn off D8

and reset the delay timer.
The adjustable resistor (RV) is used as a fixed resistor, and

moving its lever won’t have any effect.

This circuit works because capacitor C5

can store electricity. When you turn on the

circuit, electricity flows through resistor RV

into C5. When C5 gets full, electricity starts

flowing into transistor Q2, which turns on

the color LED. Pressing S2 empties C5,

and resets the timer. Capacitors C2 and

C7 also store electricity, but only small

amounts; if used in this circuit they would

appear to fill up instantly.

RV3 controls how fast electricity flows

into capacitor C5. Increasing RV3’s

value makes it take longer to charge

up C5.

SCC-350_Manual_Part_C.qxp 7/25/14 2:11 PM Page 32

Advertising