Elenco Snap Circuits® Deluxe Sound & Light Combo - Manual (Page 2)

-1-
1. Most circuit problems are due to incorrect assembly, always
double-check that your circuit exactly matches the drawing for it.
2. Be sure that parts with positive/negative markings are
positioned as per the drawing.
3. Be sure that all connections are securely snapped.
4. Try replacing the batteries.
5. If the motor spins but does not balance the fan, check the
black plastic piece with three prongs on the motor shaft, and
replace it if it is damaged (this kit includes a spare). To
replace, pry the broken one off the motor shaft using a
screwdriver, then push the new one on.
6. If a fiber optics circuit isn’t working, make sure the clear &
black cable holders are pushed all the way onto the
LED/phototransistor, and the fiber optic cable is pushed into
the holders as far as it will go. The cable should be standing
straight up in the holders.
7. If the flexible sheet in the sound energy demo container is
damaged, replace it with a spare (if one was included), or use
household plastic wrap.
8. If the echo IC (U28) stops working, turn the circuit off and on
to reset it.
ELENCO ® is not responsible for parts damaged due to incorrect
wiring.
Basic Troubleshooting
Note: If you suspect you have damaged parts, you can follow the
Advanced Troubleshooting procedure on pages 23-25 to determine which
ones need replacing.
Basic Troubleshooting 1
Parts List 2-4
How to Use Snap Circuits ® 5-7
About Your Snap Circuits ® Parts 8-11
Introduction to Electricity 12
Light in Our World 13-15
Sound in Our World 16-21
DOs and DON’Ts of Building Circuits 22
Advanced Troubleshooting 23-25
Project Listings 26-29
Projects 1 - 392 30-164
Other Snap Circuits ® Projects 165
WARNING: SHOCK HAZARD - Never
connect Snap Circuits ® to the electrical
outlets in your home in any way!
Table of Contents
WARNING: Always check your wiring before
turning on a circuit. Never leave a circuit
unattended while the batteries are installed.
Never connect additional batteries or any
other power sources to your circuits.
Discard any cracked or broken parts.
Adult Supervision: Because children’s
abilities vary so much, even with age groups,
adults should exercise discretion as to
which experiments are suitable and safe (the
instructions should enable supervising
adults to establish the experiment’s
suitability for the child). Make sure your child
reads and follows all of the relevant
instructions and safety procedures, and
keeps them at hand for reference.
This product is intended for use by adults
and children who have attained sufficient
maturity to read and follow directions and
warnings.
Never modify your parts, as doing so may
disable important safety features in them,
and could put your child at risk of injury.
CAUTION: Persons who are extremely
sensitive to flashing lights and rapidly
changing colors or patterns should exercise
caution when playing with this toy.
CAUTION: High intensity light. Do not look
directly at white LED (D6).
WARNING FOR ALL PROJECTS WITH
A SYMBOL - Moving parts. Do not
touch the motor or fan during operation.
Do not lean over the motor. Do not
launch the fan at people, animals, or
objects. Eye protection is recommended.
!
!
WARNING: CHOKING HAZARD - Small
parts. Not for children under 3 years.
!
● Use only 1.5V AA type, alkaline batteries (not
included).
● Insert batteries with correct polarity.
● Non-rechargeable batteries should not be
recharged. Rechargeable batteries should
only be charged under adult supervision, and
should not be recharged while in the product.
● Do not mix old and new batteries.
● Do not connect batteries or battery holders in
parallel.
● Do not mix alkaline, standard (carbon-zinc),
or rechargeable (nickel-cadmium) batteries.
● Remove batteries when they are used up.
● Do not short circuit the battery terminals.
● Never throw batteries in a fire or attempt to
open its outer casing.
● Batteries are harmful if swallowed, so keep
away from small children.
Batteries: !
Conforms to all applicable U.S.
government requirements.
WARNING: Some projects are intended for use with
headphones (not included in this set). Headphones
performance varies, so you should use caution. Permanent
hearing loss may result from long-term exposure to sound
at high volumes. Start with as low a volume as possible,
then carefully increase to a comfortable level. Ringing or
discomfort in the ears may indicate that the sound levels
are too high; immediately discontinue using the
headphones with this product and consult a physician.
!
SCC-350_Manual_Part_A.qxp 7/25/14 2:39 PM Page 2