Elenco Snap Circuits Motion - Manual (Page 33)

Insert some of the cardboard figures into
the 3 slots on the edge of the merry-go-
round base (the figures may need to be
punched out of a cardboard sheet). Build
this circuit and mount the merry-go-
round base onto the shaft on the geared
motor (GM).
Turn on the slide switch (S1) and watch
the show!
You can change the sound by removing
the 1-snap and 2-snap wires that are at
point A, or by moving them to be across
points B & C, or across points A & D.
Project 45 Merry-Go-Round with
Music & Light
Insert some of the cardboard figures into
the 3 slots on the edge of the merry-go-
round base (the figures may need to be
punched out of a cardboard sheet). Build
this circuit and mount the merry-go-
round base onto the shaft on the geared
motor (GM).
Turn on the slide switch (S1) and watch
the show!
You can change the sound by removing
the 1-snap and 2-snap wires that are at
point A, or by moving them to be across
points B & C, or across points A & D.
Project 46 Fast Merry-Go-Round
with Music & Light
-32-
SCM-165_Manual_061114.qxp_Layout 1 7/7/14 11:29 AM Page 33