Project 47 hypnotic discs, Project 48 strobe light with music – Elenco Snap Circuits Motion User Manual

Page 34

Advertising
background image

Project 47

Hypnotic Discs

Use the preceding circuit (Fast Merry-Go-Round

with Music & Light), but remove the cardboard

figures from the merry-go-round base and install

one of the colored discs into the base. Watch the

hypnotic patterns on the discs as they spin.

If the color LED flash rate is synchronized with the disc rotation speed, it can appear

to “freeze” parts of the spinning disc pattern. Also, as different colors flash, those

colors can seem to disappear.
More about this in project 54, which uses gears to spin the disc faster and has

adjustable speed, but does not have music.
The 1mF capacitor is used to filter the voltage to the color LED. Without it, electrical

disturbances from the speaker and geared motor would disrupt the color LED’s

flashing pattern.

-33-

Hold color LED (D8)

over disc as shown.

Tab

Slide tabs into slots.

Tab

Tab

With this disc, the white

lines are often visible

despite spinning so fast,

and

some

colors

sometimes seem to

disappear.

When red flashes on the

LED, the red spiral

pattern

seems

to

disappear. This pattern

can seem hypnotizing.

With this disc, some

colors seem to disappear

at times.

Here are some effects to watch for:

This pattern can seem

hypnotizing.

Modify the preceding circuit to be this one; which has the color LED (D8) connected

with the red & black jumper wires, and the 1mF capacitor (C7) placed where the

color LED had been. Install one of the colored discs into the merry-go-round base.
For best effects, do this in a dimly lit room. Turn on the slide switch (S1). Hold the

color LED upside down over the merry-go-round base so it shines on the spinning

disc.
Observe the effects as the color LED flashes on the disc as it spins. Try it with

different discs.
Variants: You can change the sound by removing the 1-snap and 2-snap wires that

are at point A, or by moving them to be across points B & C, or across points A & D.

Project 48

Strobe Light with Music

Tab

Slide tabs into slots.

Tab

Tab

SCM-165_Manual_061114.qxp_Layout 1 7/7/14 11:29 AM Page 34

Advertising