Elenco Snap Circuits Motion - Manual (Page 5)

How to Use Snap Circuits
®
Snap Circuits ® uses building blocks with snaps
to build the different electrical and electronic
circuits in the projects. Each block has a
function: there are switch blocks, light blocks,
battery blocks, different length wire blocks, etc.
These blocks are different colors and have
numbers on them so that you can easily
identify them. The blocks you will be using are
shown as color symbols with level numbers
next to them, allowing you to easily snap them
together to form a circuit.
For Example:
This is the switch block which is green and has
the marking on it. The part symbols in this
booklet may not exactly match the appearance
of the actual parts, but will clearly identify them.
This is a wire block which is blue and comes
in different wire lengths.
This one has the number , , , ,
or on it depending on the length of the wire
connection required.
There is also a 1-snap wire that is used as a
spacer or for interconnection between different
layers.
You need a power source to build each circuit.
This is labeled and requires two (2) 1.5V
“AA” batteries (not included).
A large clear plastic base grid is included with
this kit to help keep the circuit blocks properly
spaced. You will see evenly spaced posts that
the different blocks snap into. The base has
rows labeled A-G and columns labeled 1-10.
Next to each part in every circuit drawing is a
small number in black. This tells you which
level the component is placed at. Place all
parts on level 1 first, then all of the parts on
level 2, then all of the parts on level 3, etc.
Some circuits use the jumper wires to make
unusual connections. Just clip them to the
metal snaps or as indicated.
The set contains 9 pre-
punched cardboard
figures, which can be
inserted into slots in the
merry-go-round base.
The figures are supplied
as a single sheet; just
punch them out.
This set contains 4 pre-
punched cardboard discs.
These will be used to make
hypnotic patterns in project
47, with a strobe light in
project 48, and in other
projects. The discs are
supplied as a single sheet; just punch them out.
S1
2 3 4 5
6
B1
-4 -
To remove a disc from the holder, flip the
holder over and poke the disc out with
your finger as shown.
SCM-165_Manual_061114.qxp_Layout 1 7/7/14 11:28 AM Page 5