Project 64 audio triple detector, Project 65 vibration plane – Elenco Snap Circuits Motion User Manual

Page 42

Advertising
background image

Project 64

Audio Triple Detector

This circuit could be used as a security

system. It lights if it detects someone

moving across the room, and sounds

an alarm if someone tries to move the

circuit out of their path.

Assemble the circuit and place the base grid into the blue stand (with

the NPN transistor (Q2) closest to the stand) and carefully stand it up.

Position it near the edge of a table, facing across a room.
Turn on the slide switch (S1). An alarm sounds for a few seconds on

start-up, and then whenever the circuit detects motion, detects vibration,

or is tilted in some directions.
This circuit will work in the dark, but be careful not to hurt yourself

moving around a room in the dark.

Project 65

Vibration Plane

Note: This circuit has the

red/yellow bicolor LED

(D10) connected directly

across the batteries without

another component to limit

the current. Normally this

might damage the LED,

however Snap Circuits

®

LEDs

have

internal

protection resistors to

protect them from incorrect

wiring, and will not be

damaged.

-41-

Mount circuit on the blue stand and face across a room.

Assemble the airplane using the instructions on

page 5, install the light motor (M7) into the front

of it, then connect the other part to it (while it is

mounted on the airplane), as shown. Spread

out the jumper wires and be sure they will not

interfere with the fan on the light motor.
Place the airplane on a smooth surface and turn

on the slide switch (S1). The fan on the light

motor spins and lights, and the airplane slowly

moves around due to vibration. The red/yellow

bicolor LED (D10) also lights red, because it is

connected in series with the vibration switch

(S4), which is triggered by the vibrations.
Now take the airplane off the table and hold it in the

air, or place it on carpet. The red/yellow may not

light now because the vibrations are cushioned, and

may not be enough to trigger the vibration switch.

!

WARNING:

Moving parts. Do not

touch the fan during operation.

SCM-165_Manual_061114.qxp_Layout 1 7/7/14 11:29 AM Page 42

Advertising