EXFO FLS-5800 CD/PMD Analyzer Source - Manual (Page 21)

Setting CD/PMD Analyzer Source Parameters
CD/PMD Analyzer Source 15
Resetting the CD/PMD Analyzer Source
Resetting the CD/PMD Analyzer Source
You may want to reset the CD/PMD Analyzer Source parameters to their
original values.
To reset parameters to values at time of purchase, while turning
on the unit:
Press ENTER until the unit beeps three times.
All the user-defined parameters are automatically reset. The following
table presents the parameters and their default values.
Parameters Reset Value or State
Source OFF
Backlight ON
Video mode STD (standard)
Refresh rate 4 Hz
RS232/GPIB (remote control)
a
a. Parameter cannot be reset by a remote control command.
GPIB
GPIB address
a
12
Baud rate
a
N.A.
Flow ctrl
a
N.A.