EXFO FLS-5800 CD/PMD Analyzer Source - Manual (Page 72)

Remote Control Commands
66 FLS-5834A
IEEE 488.2 Commands—Description
*IDN?
Description The intent of the *IDN? query is for the unique
identification of devices over the system
interface.
Syntax *IDN?
Response(s) “EXFO E.-O. Engineering,FLS-5834A,xxxxxxxxxx,
2.0r0”, where
– xxxxxxxx is the serial number
– 2.0r0 is the Firmware level.
*LOK
Description This command is used to set the Remote
Lockout programming state.
Syntax *LOK<wsp><LockoutState>
Parameter(s) LockoutState:
The program data syntax for <LockoutState> is
defined as a <Boolean Program Data> element.
The <LockoutState>special forms ON and OFF
are accepted on input for increased readibility.
ON corresponds to 1 and OFF to 0.
The <LockoutState> parameter is the new
lockout state of the CD/PMD Analyzer Source:
“0”- Removing the Lockout state of the source.
“1”- Enabling the Lockout state of the source.