EXFO FTB -5240S/5240BP Optical Spectrum Analyzer for FTB 500 (NS-1434) - Manual (Page 16)

Getting Started with Your Optical Spectrum Analyzer
8 FTB-5240S/5240BP
Inserting and Removing Test Modules
3. Take the module and place it so that the connector pins are at the
back, as explained and shown below.
Identification sticker must be facing up and connector pins at the right
of the retaining screw hole.
4. Insert the protruding edges of the module into the grooves of the
receptacle’s module slot.
5. Push the module all the way to the back of the slot, until the retaining
screw makes contact with the receptacle casing.
6. Place the FTB-500 so that its left panel is facing you.
Protruding edges
at bottom
Identification sticker
facing up
Connector
pins at the
back Retaining screw
hole at the
back
FTB-500 right panel