EXFO FTB-8100 Series Transport Blazer for FTB-200 - Manual (Page 106)

Smart Mode
94 FTB-8100 Series Transport Blazer
Creating and Starting a Test Case Using SmartMode
Creating and Starting a Test Case Using
SmartMode
Note: The default test preferences will be used for the test. For example, the laser
will be Off if not enabled from the Default Test Preferences on page 382.
To setup a test case using SmartMode:
1. Select the SONET/SDH signal corresponding to the signal connected to
the module.
2. Press either Not Scanned. Click here or on the “Smart Scan” button
to scan or Smart Scan. A Trib Scan is also required for LOP test
purposes otherwise, a HOP test case will be created even if the signal
contains LOP.
3. The structure of the signal is displayed when the scan succeeds. If the
scan succeeds, press Launch Test to start the test.
Note: The user must select the desired HOP and LOP timeslots before pressing
Launch Test otherwise, the first valid timeslot scanned will be used.