EXFO FTB-8100 Series Transport Blazer for FTB-200 - Manual (Page 338)

10G Ethernet Tabs
326 FTB-8100 Series Transport Blazer
Configuration TX
Stream
³
Enable: Allows enabling the stream. The stream will be generated only
when the test is started.
Note: The stream can be enabled/disabled even when the test is started and
running. A stream cannot be enabled if its MAC address is not valid.
Note: The stream is automatically enabled when the test is started and
automatically disabled when the test is stopped.
³
TX Rate: Allows the selection of the stream rate. The default TX rate is
100%. TX Rate is only available when the stream is not enabled.
Unit choices are %, bps, Kbps, Mbps, Gbps, Bps, KBps, MBps, GBps,
fps, and IFG. The default setting is %.
Frame Configuration
Note: The following frame configuration parameters are only available when the
stream is not enabled.
³
Frame Size (Bytes): Select the frame size for the stream.
Note: Sending traffic with frame size >1518 in switched network may result in
losing all frames.
VLAN
Frame Size
Minimum Maximum
None
1 Tag
48
52
16000
16000