EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 264)

Test Functions
254 FTB/IQS-85100G
40/100G Advanced - CFP/CFP2 Control
CFP/CFP2 Control Pins
Allows the following CFP/CFP2 control pin settings. Refer to the CFP MSA
standard for more information.
Note: To apply any control, first select its check box then clear it; the control is
applied only when the selected check box is cleared.

TX & RX IC RST check box (cleared by default).

Connector Power Rating, choices are:

TX Disable check box (cleared by default).

Module Low Power Mode check box (cleared by default).

Module Reset check box (cleared by default).

Module Power Shutdown check box (cleared by default).
CFP/CFP2 Status Pins
Gives the following CFP’s pin status: Hi Power On, Module Ready, Module
Fault, Module Absent, RX Loss of Signal, and Global Alarm. Refer to the
CFP MSA standard for more information.
Connector Power Rating
CFP Power Class 1 (<= 8W)
Power Class 2 (<= 16W)
Power Class 3 (<= 24W)
Power Class 4 (<= 32W) (default)
CFP2 Power Class 1 (<= 3W)
Power Class 2 (<= 6W)
Power Class 3 (<= 9W)
Power Class 4 (<= 12W) (default)