EXFO MaxTester MAX-630 - Manual (Page 42)

Setting Up DSL/IP Tests
36 MAX-630
Test Configuration

VPI (ATM mode only) is the virtual path identifier (VPI) ranging from 0
through 255 for the downstream channel.

VCI (ATM mode only) is the virtual circuit identifier (VCI) ranging from
32 through 65535 for the downstream channel.

Encapsulation Type depends on the network configuration and sets
the ATM to either LLC also known as LLC-SNAP (logical link
control-sub network address protocol) or VC_MUX (virtual channel
multiplex).

VLAN Support enables the unit to tag/untag ethernet frames.

VLAN ID is a virtual local area network (VLAN) tag ranging from 0
through 4094. The entry is available only when VLAN Support is
Enable.

Vendor ID is the name of the unit. This entry is available only when
Access Mode is DHCP.

Local Mac Address is the internal MAC address of the unit: either
MaxTester or User Defined.

Mac Address is a specific MAC address, in a hexadecimal format, if
User Defined was selected for the previous parameter. This entry is
available only when Access Mode is DHCP or Static.
The following parameters are available only when Access Mode is PPPoE
or PPPoA.

Login Name is your user ID.

Password is your password.

Obtain IP is either Dynamic where the access concentrator or
broadband remote access server assigns a temporary IP address to
the unit, or Static where you enter the IP address of the unit.