Instructions for use – Glow-worm Chatsworth 4 User Manual

Page 3

Advertising

221907C

Diagram 1

MINIMUM FLAT AREA AND FIXTURES CLEARANCES

6215

690

150

800 WIDE FRAME

780 STANDARD FRAME

Chatsworth
Illustrated
(same dimensions
for Dovedale)

150

Instructions for Use

The Gas Safety (Installation and Use)

Regulations

In your interests and that of safety it is the Law that ALL gas
appliances are installed by a competent person in accordance
with the current issue of the above regulations.

Glow-worm Dovedale BBU or Chatsworth BBU

with Glow-worm BBU 45/4 or BBU 54/4.

These instructions should be read and carefully followed for the
safe and economical use of your combined fire front and central
heating boiler.

The fire front can be used only with special Glow-worm 45/4,
54/4 Back Boiler Units.

The fire front and back boiler must be installed as a complete
appliance.

The boiler and fire front can be used either together or
independently.

In the event of a power failure the fire front can still be used on
its own, see “Lighting the Fire Front”.

Important Notice

This appliance is for use only on G20 gas.

A slight smell may occur, for a short time, after initial lighting, this
is quite normal and it will quickly disappear.

With a little use the interior of the fire front will discolour and
acquire the appearance of a solid fuel fire.

CAUTION: Combustible furniture or materials should not be
placed closer than 1metre radius in front of the fire front, refer
to diagram 1 for side clearances.

Clothing or other flammable material must not be placed on the
fire front castings.

Soft wall coverings, for example, blown vinyl wallpaper, are
easily affected by heat, they may, therefore, scorch or become
discoloured when close to a heating appliance. Please bear this
in mind when having a heating appliance installed and when
redecorating

WARNING

The fire front has a naked flame.

A fireguard must be used for the protection of children, the infirm
or elderly.

A fireguard should comply with the current issue of BS6539
“Fireguards for use with solid fuel appliances” or the current
issue of BS6778 “Fireguards for use with portable, free standing
or wall mounted heating appliances”.

Do not allow any refuse or rubbish to be burnt on this fire front,
or any objects to be placed in the flue exit.

Maintenance/Servicing

To ensure the continued efficient and safe operation of the
appliance it is recommended that it is checked and serviced as
necessary at regular intervals. The frequency of servicing will
depend upon the particular installation conditions and usage,
but in general once a year should be enough.

If this appliance is installed in a rented property there is a duty
of care imposed on the owner of the property by the current
issue of the Gas Safety (Installation and Use) Regulations,
Section 35.

It is the law that this work be carried out by a competent person.

To obtain service, please call your installer or Heatcall (Glow-
worm’s own service organisation) using the telephone number
given on the front page of these instructions.

Regularly make sure that the purpose provided ventilation is
free from obstructions.

Please be advised that the ‘Benchmark’ logbook (supplied with
back boiler unit) should be completed by the installation engineer
on completion of commissioning and servicing.

All CORGI Registered Installers carry a CORGI ID card, and
have a registration number. Both should be recorded in your
boiler Logbook. You can check your installer is CORGI registered
by calling CORGI direct on :- 01256 372300.

Heat Output - Fire Front

The gas fire front will work for about 4 hours 20 minutes at full
on rate on one therm of gas. The price of a therm of gas will vary
according to the tariff.