Glow-worm Chatsworth 4 - Manual (Page 5)

5 221907C
5897
Diagram 3
CONTROL
KNOB
OFF POSITION
COKE SETTING
HEAT SETTING 3
HEAT SETTING 2
HEAT SETTING 1
IGNITION POSITION
6035
Diagram 4
MATCH
Instructions for Use
the boiler user control panel, see diagram 2.
The pilot will remain alight if there is a call for heat. To relight
the main burner turn control thermistor knob “A” clockwise to the
desired setting between the minimum and maximum position.
For longer periods, turn control thermistor knob “A” anti-clockwise
so that the pointer is against the “Reset” position on the boiler
user control panel. Switch off the electrical supply to the
appliance.
To relight follow the full lighting instructions given above.
Lighting the Fire Front
Please read the information about the safety device at the
beginning of these User Instructions before lighting the fire.
IMPORTANT If the burner does not light (instructions below)
within three seconds, return the knob to the OFF position, wait
for 10 seconds and repeat the following lighting operation.
1) Slide the control knob down to the “ignition position”, against
its stop and hold in position, see diagram 2, clicking of the
ignition will be heard and the burner will light.
2) Keep the knob in the ignition position for fifteen seconds after
the burner has lit. The ignition system will continue to operate,
indicated by the clicking at this time.
Note: Before releasing, ensure the control knob is against its
stop, to engage the flame supervision device.
3) Move the control knob to the desired position.
Note: Setting 1 is Low, Setting 3 or Coke is High.
To change settings, refer to diagram 3.
Note: Coke setting gives off a high glow, but a low flame effect.
If the burner goes out, wait three minutes before relighting, for
any other reason wait for two minutes.
Lighting the Fire with a Match or Spill
As a temporary measure the fire may be lit with a spill or long
match as follows:-
WARNING. Take care as the burner has a naked flame.
Hold a lighted spill or long match and put it into the hole as
shown in diagram 4 Position the spill so that the flame is over
the burner.
Keep the spill in place, slide the control knob down to the
“ignition position”, against its stop and hold, see diagram 3, the
burner will light, remove the spill.
Keep the knob in the ignition position for fifteen seconds after
the burner has lit.
Before releasing, ensure the control knob is fully depressed
against its stop, to engage the flame supervision device.
Once lit move the control knob to the desired setting.
Note: Setting 1 is Low, Setting 3 or Coke is High.
Note: Coke setting gives off a high glow, but a low flame effect.
If the burner goes out, wait three minutes before relighting, for
any other reason wait for two minutes.
This is a temporary measure only The ignition system should
be repaired or the battery be replaced as soon as possible.
Soot Accumulation
Note: A small amount of soot accumulating is quite natural and
will give the fire a more realistic effect.
If desired, these minor soot deposits can be burned off by
running at the coke setting for approx. one hour.
Lighting the Boiler
The boiler controls are placed behind the ashpit cover.
To remove the ashpit cover unhook from the fret.
Refer to diagram 2 to identify the boiler controls.