Glow-worm Chatsworth 4 - Manual (Page 6)

6 221907C
9457
Diagram 5
ASHPIT
COVER
FRET
FRET
RETAINING
BRACKET
Chatsworth illustrated
Instructions for Use
Cleaning your Fire
WARNING. This fire contains metal parts (components) and
care should be taken when handling and cleaning, with particular
regard to edges.
Any cleaning must only be done when the fire is cold.
If large pieces of debris are found the chimney should be
inspected and the fire serviced before further use.
Under normal conditions dusting the surrounds of the fire
should be enough. An occasional wipe over with a damp cloth
will help to remove any marks.
Do not use an abrasive cleaning powder or liquid.
To Clean the Fuel and Fuel Supports - this can
be done by the User
Should any soot accumulation become excessive, the fuel
effect pieces should be removed from the fire for cleaning.
Cleaning should be carried out in a well ventilated area or in the
open air, by gently brushing with the pieces held away from your
face so that you avoid inhaling the dust. We do not recommend
the use of a normal domestic vacuum cleaner, which may blow
dust back into the air.
Remove the fret and ash pit cover, see diagram 5.
Take care not to damage the frame.
Following steps 1 to 8 in reverse order, remove the fuel effect
pieces and fuel effect supports, see diagram 6.
Be careful as with use they become fragile.
Clean the fuel effect pieces and fuel effect supports with a soft
brush,
as above.
With the fuel effect pieces and fuel effect supports removed, the
base of the appliance
may be cleaned with a vacuum cleaner.
Note: After cleaning, always adhere strictly to the instructions
when reassembling the fuel effect supports and fuel effect
pieces.
Use only the fuel effect approved for this fire.
Do not use more fuel effect pieces than specified.
Fuelbed Fitting
CAUTION. If the fuel effect supports and fuel effect pieces are
damaged, do not light the fire or further test until replacement
parts are fitted.
USE ONLY THE FUEL EFFECT APPROVED FOR THIS FIRE.
DO NOT USE MORE FUEL EFFECT PIECES THAN
SPECIFIED.
DO NOT CHANGE THE LAYOUT OF THE FUEL EFFECT
PIECES.
The importance of positioning the fuel effect pieces correctly
cannot be overemphasised if sooting is to be avoided. The
flame effect may also be impaired and the life of the fuel effect
pieces reduced if assembly directions are not followed.
Before positioning the fuel effect pieces, study carefully the
illustrations showing the layout procedure of the pieces, see
diagram 6.
Follow the steps which are shown numerically in the fuelbed
fitting sequence starting at Step 1, making sure that each stage
is completed before carrying on to the next and that all written
instructions are adhered to, see diagram 6.
STEP 1. When fitting the front support make sure the feet are
located at the back of the retaining lip and the support fits
between the brackets.
STEP 2. Fit the side supports tightly into the front corners
touching the side and front of the appliance.
STEP 3. Fit the rear support, making sure it sits on the bottom
of the brackets, by pushing it down firmly.
STEP 4. Fit the middle support over the burner making sure it
sits behind the brackets on the burner. Keep the support clear
of the cross lighting ports.
STEP 5. Place the two large fuel effect pieces with the flat bases
and round indents down. Leave gaps around the pieces.
NOTE: The remaining fuel effect pieces can be turned as
requires to maintain a constant gap around each fuel effect
piece.
STEP 5 CONTINUED. Place four small fuel effect pieces
starting from the outside, leaving gaps around the pieces. The
left hand outside piece must touch the side of the fire. The right
hand outside piece must touch the left hand side of the burner
support bracket.
STEP 6. Place seven small fuel effect pieces on the middle
support starting from the outside, leaving gaps around the
pieces. The two outside pieces touch the sides of the fire.